عرض بسيط للتسجيلة

المؤلفMjalli, Farouq
المؤلفAbdel-Jabbar, Nabil
المؤلفFletcher, John
تاريخ الإتاحة2010-01-07T10:00:29Z
تاريخ النشر2004-05-26
اسم المنشورChemical Engineering and Processing: Process Intensification
المعرّفhttp://dx.doi.org/10.1016/j.cep.2004.05.016
الاقتباسFarouq S. Mjalli, Nabil M. Abdel-Jabbar, John P. Fletcher, Modeling, simulation and control of a scheibel liquid–liquid contactor: Part 1. Dynamic analysis and system identification, Chemical Engineering and Processing: Process Intensification, Volume 44, Issue 5, May 2005, Pages 543-555
معرّف المصادر الموحدhttp://hdl.handle.net/10576/10633
الملخصThe liquid–liquid extraction process is well-known for its complexity and often entails intensive modeling and computational efforts to simulate its dynamic behaviour. However, rigorous mathematical models are usually impractical or are of limited usefulness for control system design. Therefore, there is a need to derive simpler models for this process. Reduced-order linear models can be derived through applying system identification on the input–output simulation data. As a first step, a rigorous model for dynamic simulation of an extraction process is developed. This model employs an improved detailed stage-wise mixing stage with backmixing and it takes into account the variation in hydrodynamics, mass transfer, and physical properties throughout the length of the extraction column. It also approximates end effects by incorporating two mixing stages at both ends in addition to calculation of mass transfer within calming zones through the use of a mass transfer weight factor. The model is validated with dynamic experimental data for a nine stage Scheibel extraction column of type I. The simulation model is shown to be accurate for prediction of process behaviour under different operating conditions. Dynamic analysis of the process is conducted on the developed rigorous simulation model. Then, system identification is applied to derive linear time-invariant reduced-order models, which relate the input process variables (agitator speed, solvent feed flowrate and concentration, feed concentration and flowrate) to the output process variables (raffinate concentration and extract concentration). The identified model predictions are found to be in a good agreement with the rigorous ones.
اللغةen
الناشرElsevier B.V.
dc.relation.haspart http://dx.doi.org/10.1016/j.cep.2004.05.015
dc.relation.isreferencedby http://dx.doi.org/10.1016/j.cep.2009.01.001
الموضوعScheibel
Extraction dynamics
Liquid–liquid
Backmixing
Backflow model
Stagewise
System identification
العنوانModeling, simulation and control of a scheibel liquid–liquid contactor: Part 1. Dynamic analysis and system identification
النوعArticle


الملفات في هذه التسجيلة

الملفاتالحجمالصيغةالعرض

لا توجد ملفات لها صلة بهذه التسجيلة.

هذه التسجيلة تظهر في المجموعات التالية

عرض بسيط للتسجيلة