Search
Now showing items 31-40 of 42
A cascaded boost inverter-based open-end winding three-phase induction motor drive for photovoltaic-powered pumping applications
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
Although PWM inverter-fed drives are now a well-established technology in industrial applications, the generation of common mode voltage associated with these modulation techniques results in undesired bearing current and ...
Effectiveness of Ni incorporation in iron oxide crystal structure towards thermochemical CO2 splitting reaction
(
Elsevier Ltd
, 2017 , Article)
In this study, Ni-doped iron oxide (NixFe3−xO4) materials were synthesized via the 1,2-epoxypropane assisted sol-gel method by varying the molar concentration of Ni from x=0.2 to 1. Sol-gel derived NixFe3−xO4 gels were ...
CHAPTER 6: Atomic and Molecular Functionalization of Graphitic Carbon Nitride for Solar Cell Applications
(
Royal Society of Chemistry
, 2021 , Book chapter)
Graphitic carbon nitride (g-C3N4) nanomaterials have attracted great attention in various energy and environmental applications owning to their unique physical and chemical properties. The utilization of gCNs in solar-driven ...
Phase change materials for thermal energy storage applications in greenhouses: A review
(
Elsevier Ltd
, 2022 , Article)
Greenhouses represent one of the largest energy-demanding sectors, requiring energy for indoor environment control for plant growth and crop yield. Thermal energy storage using phase change materials (PCMs) has been ...
Optimal correlation of non-renewable and renewable generating systems for producing hydrogen and methane by power to gas process
(
Elsevier Ltd
, 2019 , Article)
This paper presents an efficient framework for converting renewable energy to gas and reducing Carbon dioxide (CO 2 ) footprint at the same time. The problem is presented in two levels. The first level is a minimization ...
Synthesis and characterization of nanocrystalline CoFe2O4-zirconia via propylene oxide aided sol-gel method
(
Elsevier Ltd
, 2018 , Article)
In this study, a Co ferrite/ZrO2 ceramic nanomixture, with a uniform distribution of Co ferrite and ZrO2, was synthesized by the propylene-oxide-assisted sol gel method. Cobalt, iron, and zirconium nitrate salts were used ...
Thermal conductivity and latent heat thermal energy storage properties of LDPE/wax as a shape-stabilized composite phase change material
(2014 , Article)
Phase change material (PCM) composites based on low-density polyethylene (LDPE) with paraffin waxes were investigated in this study. The composites were prepared using a meltmixing method with a Brabender-Plastograph. The ...
Application of cobalt incorporated Iron oxide catalytic nanoparticles for thermochemical conversion of CO2
(
Elsevier B.V.
, 2019 , Article)
This investigation describes the application of the sol-gel synthesized CoxFe3?xO4 (CF) materials towards the solar thermochemical fuel production. The CF materials were derived by sol-gel method (where x was varied in the ...
High-performance adaptive Perturb and observe MPPT technique for photovoltaic-based microgrids
(
IEEE
, 2011 , Article)
Solar photovoltaic (PV) energy has witnessed double-digit growth in the past decade. The penetration of PV systems as distributed generators in low-voltage grids has also seen significant attention. In addition, the need ...
Thermochemical copper Oxide - Copper sulfate water splitting cycle for solar hydrogen production
(
TechConnect
, 2016 , Conference Paper)
In this paper, the solar thermochemical copper oxide - copper sulfate (CO-CS) water splitting cycle is thermodynamically investigated. CO-CS cycle consists of two steps: first step - exothermic oxidation of CuO via water ...