Search
Now showing items 1-10 of 21
HVDC shunt tap based on series-input parallel-output DC-AC multi-module VSCs with DC voltages balancing
(
Institution of Engineering and Technology
, 2014 , Conference Paper)
Conventionally, tapping-off a small amount of power from an HVDC transmission line to a three-phase local network can be achieved using a DC-to-AC voltage source converter (VSC) followed by a step down transformer. In order ...
A New Six-Phase FSCW Layout for Permanent Magnet Synchronous Wind Generators
(
Institute of Electrical and Electronics Engineers Inc.
, 2020 , Conference Paper)
This paper proposes a new non-overlapped six-phase Fractional Slot Concentrated Winding (FSCW) layout for a Permanent Magnet (PM) synchronous wind generator with an outer rotor and surface mounted magnets. The proposed ...
Carrier-Based PWM Strategy for Quasi-Z Source Nine-Switch Inverters
(
Institute of Electrical and Electronics Engineers Inc.
, 2019 , Conference Paper)
Nine-switch Inverters (NSIs) have been proposed to accommodate the independent control of dual AC motors or in six-phase drives. This topology reduces the number of active switches by 25% compared with conventional Voltage ...
A cascaded boost inverter-based open-end winding three-phase induction motor drive for photovoltaic-powered pumping applications
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
Although PWM inverter-fed drives are now a well-established technology in industrial applications, the generation of common mode voltage associated with these modulation techniques results in undesired bearing current and ...
A directional protection technique for MTDC networks
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
This paper suggests a new protection algorithm for a multi-terminal direct current (MTDC) networks. The current values and directions at each bus connecting more than one line are determined. The measured values of line ...
A Zeta-converter based four-switch three-phase DC-AC inverter
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
Minimizing the number of active switching devices in switched-mode power-electronic systems has a significant importance. Reduced complexity and switching losses, low cost, weight, and volume and high reliability are the ...
A nine-arm modular multilevel converter (9A-MMC) for six-phase medium voltage motor drives
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
Dual three-phase (asymmetrical six-phase) induction motors have received significant attention in high power medium voltage drive applications. Typically, two three-phase voltage source converters are needed to feed such ...
A five-phase induction machine model using multiple DQ planes considering the effect of magnetic saturation
(
Institute of Electrical and Electronics Engineers Inc.
, 2014 , Conference Paper)
Multiphase phase induction machines are usually modeled using multiple dq planes, where complete decoupling between these sequence planes is usually assumed. This assumption may be accepted if the magnetic circuit is assumed ...
A new modulation technique for wide-range control of output voltage in Z-source inverters
(
Institute of Electrical and Electronics Engineers Inc.
, 2014 , Conference Paper)
Z-source inverter (ZSI) is recently proposed as a single-stage power conversion topology. It adds voltage boost capability for complementing the usual voltage buck operation of the traditional voltage source inverter with ...
A grid-connected HVDC shunt tap based on series-input parallel-output DC-AC multi-module 2-level voltage source converters
(
Institute of Electrical and Electronics Engineers Inc.
, 2015 , Conference Paper)
Tapping-off a small amount of power from an HVDC transmission line to a three-phase local grid can be achieved by using shunt or series HVDC taps. This paper proposes a new grid-connected HVDC shunt tap. The proposed tap ...