Search
Now showing items 1-7 of 7
Corrosion Detection Using Transfer Learning-Based Modeling for Image Classification
(Mechanical Engineering, 2019 , Master Thesis)
This study uses image classification-based transfer learning to train models on the task of corrosion-detection on metallic surfaces. This is done by photographing images of samples of aluminium, iron and steel before and ...
Reduced Graphene Oxide Incorporated GELMA Hydrogel Promotes Angiogenesis for Wound Healing Applications
(Mechanical Engineering, 2019 , Master Thesis)
Non-healing or slow healing of chronic wounds is among the serious
complications of diabetes. The decrease in blood supply due to lack of angiogenesis
leads to reduced supply of oxygen, nutrients and growth factors ...
Numerical Analysis of a Sacrificial Cladding Panel Subjected to Localized Near-Field Impulsive Load
(Mechanical Engineering, 2019 , Master Thesis)
Extensive research focus had been given to sacrificial sandwiched panels used
to mitigate the effects of blast loads. This is due to their ability to distribute the load
and absorbing significant portions of the blast ...
Novel Process for Designing Topology Optimized Femoral Stems Printable by Metal Additive Manufacturing
(Mechanical Engineering, 2019 , Master Thesis)
Total hip arthroplasty faces an issue of the high cost and risks of revision
surgeries. Studies show that more than 50% of the revision surgeries are the
consequence of the aseptic loosening of the implant. The cause ...
Numerical Simulation of Dynamic Response For Misalignment In Coupled Shafts
(Mechanical Engineering, 2019 , Master Thesis)
Preceded by unbalance, misalignment is the second most common fault in
rotating machinery. The impact of misalignment fault on equipment can be severe and
may considerably shorten the machine’s lifetime. This dissertation ...
UV Stabilization and Flame Retardancy of Polyethylene for Piping Applications
(Mechanical Engineering, 2019 , Master Thesis)
This work presented an investigation of the ultra violet (UV) stability and flame
retardancy of linear low-density polyethylene (LLDPE) and low-density
polyethylene manufactured in autoclave process (LDPE-A), that are ...
Evaluation of 316L Stainless Steel Part Fabrication Using Additive and Subtractive Manufacturing: A Guideline for Process Selection
(Mechanical Engineering, 2019 , Master Thesis)
Due to its favorable mechanical properties and high corrosion resistance and high carbon content, Stainless steel 316L is widely used in many applications including marine, biomedical and aerospace industries. With additive ...