Search
Now showing items 31-40 of 44
A single-stage three-phase inverter based on cuk converters for PV applications
(
Institute of Electrical and Electronics Engineers Inc.
, 2014 , Conference Paper)
This paper presents a new three-phase inverter based on the Cuk converter. The main feature of the proposed topology is that the energy storage elements, such as inductors and capacitors, can be reduced in order to improve ...
Elimination of reverse recovery effects associated with CoolMOS devices employing current source inverter topology
(
IET
, 2012 , Conference Paper)
MOSFET transistors are continuously being an essential part of power electronic converters due to their low switching losses at high switching frequencies. However, the traditional power MOSFET suffers from a relatively ...
High-performance adaptive Perturb and observe MPPT technique for photovoltaic-based microgrids
(
IEEE
, 2011 , Article)
Solar photovoltaic (PV) energy has witnessed double-digit growth in the past decade. The penetration of PV systems as distributed generators in low-voltage grids has also seen significant attention. In addition, the need ...
Fault ride-through capability enhancement based on flywheel energy storage system for wind farms connected via VSC high voltage DC transmission
(
Institution of Engineering and Technology
, 2012 , Conference Paper)
This paper proposes a recovery strategy for wind energy-fed voltage source converter high voltage DC transmission systems, capable of maintaining power balance between the AC and DC sides during different AC faults. This ...
Single phase grid connected current source inverter: Mitigation of oscillating power effect on the grid current
(
Institution of Engineering and Technology
, 2011 , Conference Paper)
Although voltage source inverters (VSIs) are the most common DC-AC grid-tied converters, current source inverters (CSIs) are considered to be promising candidate, thanks to their low THD voltages/currents and inherent ...
Sinusoidal PWM modulation technique of five-phase current-source-converters with controlled modulation index
(
Institute of Electrical and Electronics Engineers Inc.
, 2014 , Conference Paper)
Applications such as multiphase machine drives and wind energy conversion systems are normally based on voltage source converters (VSCs) which feature a convenient and familiar control scheme. In high-power medium voltage ...
Flywheel energy storage system based on boost DC-AC converter
(
http://dx.doi.org/10.1049/cp.2011.0194
, 2011 , Conference Paper)
An additional DC-DC boost converter is used in conventional configuration of Flywheel Energy Storage System (FESS) to regulate the output voltage during flywheel low speeds. This paper presents a new FESS based on the boost ...
Simplified generic on-line PWM technique for single phase grid connected current source inverters
(
Institute of Electrical and Electronics Engineers Inc.
, 2012 , Conference Paper)
Mandatory restrictions for a current source inverter's (CSI's) proper operation, like continuity of the DC link current, complicate the corresponding PWM generation especially in the case of single phase systems. Classical ...
Multi-module Bi-directional Buck-Boost Inverter-based HVDC back-to-back transmission system
(
IEEE
, 2013 , Conference Paper)
Offshore wind energy is now seen as a key contributor to the renewable energy future. HVDC technology is among the chief technologies enabling widespread use of offshore wind. This paper proposes a new configuration, namely, ...
Studying the effect of over-modulation on the output voltage of three-phase single-stage grid-connected boost inverter
(
Elsevier B.V.
, 2013 , Article)
Voltage boosting is very essential issue in renewable-energy fed applications. The classical two-stage power conversion process is typically used to interface the renewable energy sources to the grid. For better efficiency, ...