بحث بسيط
السجلات المعروضة 11 -- 20 من 49
Potential of geothermal energy for electricity generation in Qatar
(
Canadian Institute of Mining, Metallurgy and Petroleum
, 2013 , Conference Paper)
There is general acceptance that climate change, which is the most important challenge facing humanity, is anthropogenic and attributed to fossil fuel consumption. Therefore, improving the performance of our existing energy ...
Recycling low grade waste heat to electricity
(
Canadian Institute of Mining, Metallurgy and Petroleum
, 2013 , Conference Paper)
Most mining and metallurgical industries produce relatively large quantities of low grade waste heat which they vent, for the most part, to the environment. To date, little is being done to recover some of this heat and ...
Optimizing multi-objective dynamic facility location decisions within green distribution network design
(
Elsevier
, 2014 , Conference Paper)
Despite the surge of sustainable economic development which inspires corporations to optimize investment on environmental-friendly infrastructural facilities, limited pragmatic evidences are observed in product-service ...
New vehicle bumper design for pedestrian protection during impact
(
Institute of Physics Publishing
, 2015 , Conference Paper)
This study discusses the influence of the active bumper design on the performance of the selected current bumper in terms of pedestrian protection by using finite element method. The legform impactor is used to test the ...
Electrospun polymer nanocomposite scaffolds containing metal oxide nanoparticles for diabetic wound healing
(
Hamad bin Khalifa University Press (HBKU Press)
, 2018 , Conference Paper)
It is very important to treat diabetic foot injuries at early stage since even minor wounds can turn into serious foot ulcers which can lead to the amputation of the entire foot if not treated early. The management of ...
Influence of Sinusoidal Drive Speed Modulation on Rotor with Continuous Stator Contact
(
Hamad bin Khalifa University Press (HBKU Press)
, 2016 , Conference Paper)
Torsional vibrations experienced by drill strings can be detrimental to drilling operations. With a goal of understanding torsional vibrations experienced by drill strings and determining means to attenuate undesired ...
A Methodology for daylight optimisation of high-rise buildings in the dense urban district using overhang length and glazing type variables with surrogate modelling
(
Institute of Physics Publishing
, 2019 , Conference Paper)
Urbanization and population growth lead to the construction of higher buildings in the 21st century. This causes an increment on energy consumption as the amount of constructed floor areas is rising steadily. Integrating ...
Investigation of the Effect of the Force-Frequency on the Behaviour of a New Viscous Damper for Railway Applications
(
Qatar Univesrity Press
, 2020 , Conference Paper)
The primary purpose of this work is to experimentally investigate the damping
coefficient of a viscous damper, intended to be used in railway applications to reduce
noise emission. The viscous shock absorber used in this ...
Uniform fractional factorial design tables for energy piles with maximum thermal conductance
(
WITPress
, 2017 , Conference Paper)
Energy Piles are the heat exchangers of Ground Source Heat Pumps (GSHP) that transfer the buildings heat to the lower temperature shallow ground reducing the energy consumption in the cooling of buildings. These piles are ...
Using Electrospinning Technique for Preparation of Cobalt Hydroxide Nanoparticles
(
Hamad bin Khalifa University Press (HBKU Press)
, 2016 , Conference Paper)
Cobalt hydroxide or cobaltous hydroxide or cobaltous hydrate, has attracted increasing attention in recent years because of its novel electric and catalytic properties and important technological applications, for examples ...