Search
Now showing items 31-40 of 42
Study of diesel-biodiesel blends combustion and emission characteristics in a CI engine by adding nanoparticles of Mn (II) supramolecular complex
(
Elsevier B.V.
, 2020 , Article)
The supramolecular complex (SC1) [Mn(EIN)4(NCS)2] was synthesized and characterized as a new nanosized emulsion additive to improve the fuel incineration and emission formation behavior of a diesel-biodiesel blends-fueled ...
Sawdust-based superhydrophobic pellets for efficient oil-water separation
(
Elsevier Ltd
, 2020 , Article)
Severe water pollution by means of oil is the major issue worldwide. Emerging materials like superhydrophobic surfaces have shown immense potential to control this issue. Herein we utilized low-cost Sawdust-Polystyrene (SD ...
Effect of cultivation parameters and heat management on the algae species growth conditions and biomass production in a continuous feedstock photobioreactor
(
Elsevier Ltd
, 2020 , Article)
The sunshine heat flux is having an essential impact on the photobioreactor system temperature. However, optimal algae growth rates have gained if the algal growth media temperature located between 25 and 30 °C, for most ...
Investigation of various Mg(x)Fe(1−x)2O4 (x = 0.1, 0.5 and 0.9) nanostructures as a resistive and flexible LPG sensor
(
Elsevier Ltd
, 2020 , Article)
This report talks in detail about the successful synthesis of nanoparticle material Mg(x)Fe(1−x)2O4 (x = 0.1, 0.5 and 0.9) through a simple and inexpensive sol-gel auto-combustion process and its application as a gas sensor. ...
Plasticizer enhancement on the miscibility and thermomechanical properties of polylactic acid-chitin-starch composites
(
MDPI AG
, 2020 , Article)
In previous research, a polylactic chitin starch composite was prepared without the use of a solvent to enhance the miscibility. In this study, a polylactic acid (PLA) chitin starch composite was produced with chloroform ...
Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites
(
SAGE Publications Ltd
, 2020 , Article)
The aim of the present study is to investigate the structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites. Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, ...
Dynamic mechanical analysis and broadband electromagnetic interference shielding characteristics of poly (vinyl alcohol)-poly (4-styrenesulfonic acid)-titanium dioxide nanoparticles based tertiary nanocomposites
(
Taylor and Francis Inc.
, 2020 , Article)
Novel tertiary nanocomposite films comprising of poly (vinyl alcohol) (PVA), poly (4-styrenesulfonic acid) (PSSA) and titanium dioxide (TiO2) nanoparticles (NPS) were prepared using simple solvent casting method. The ...
Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites
(
SAGE Publications Ltd
, 2020 , Article)
The aim of the present study is to investigate the effect of alumina (Al2O3)–carbon (C) reinforcement on the properties of aluminium matrix. Aluminium matrix reinforced with Al2O3–carbon (2.5, 5, 7.5 and 10 wt.%) in equal ...
Enhanced LPG Sensitivity for Electron Beam Irradiated Al-ZnO Nanoparticles
(
Wiley-VCH Verlag
, 2020 , Article)
Al doped and un-doped ZnO thin films are coated on glass substrate by successive ionic layer adsorption and reaction technique with varying doping concentrations of Al from 3 to 7 at%. The samples are annealed at 450 °C ...
Enhanced corrosion protection of Epoxy/ZnO-NiO nanocomposite coatings on steel
(
MDPI AG
, 2020 , Article)
ZnO-NiO nanocomposite with epoxy coating on mild steel has been fabricated by the sol–gel assisted method. The synthesized sample was used to study corrosion protection. The analysis was performed by electrochemical impedance ...