CO2 capture from lime kiln using AMP-DA2MP amine solvent blend: A pilot plant study
المؤلف | NwaohaC. |
المؤلف | TontiwachwuthikulP. |
المؤلف | BenamorA. |
تاريخ الإتاحة | 2019-10-03T10:50:02Z |
تاريخ النشر | 2018 |
اسم المنشور | Journal of Environmental Chemical Engineering |
المصدر | Scopus |
الرقم المعياري الدولي للكتاب | 22133437 |
الملخص | This experimental study covered pilot plant analysis of novel AMP and 1,5–diamino–2–methylpentane (DA2MP) amine solvent blend for CO2 capture from a lime kiln. The gas flow rate (F(GAS)), amine solution flow rate (F(amine)), CO2 concentration and reboiler temperature (T(REB)) were kept at 14 SLPM, 50 mL/min, 30 vol.% CO2 (N2 balance) and 120 °C respectively. The AMP concentration was kept at 2 kmol/m3 while DA2MP was varied from 1.5 kmol/m3 to 2 kmol/m3. The MEA and AMP-DA2MP comparative analysis was based on rich amine loading (αrich, mol CO2/mol amine), lean amine loading (αlean, mol CO2/mol amine), cyclic loading (CL, mol CO2/mol amine), cyclic capacity (CC, mol CO2/L–amine soln.), CO2 absorption rate (rabs, g–CO2/hr), CO2 absorption efficiency (%), regeneration energy (Qreg, GJ/tonne CO2), absorber overall average volumetric mass transfer coefficient (KGav(ave), kmol/kPa.hr. m3), desorber mass transfer coefficient (KLav, hr–1), initial amine solution utilized (Aminesoln._utilized, g-amine soln./g-CO2) and initial amine solution cost (US$/g-CO2). The influence of sensible energy (Qsen, GJ/tonne CO2), vaporization energy (Qvap, GJ/tonne CO2), and desorption heat (ΔHdes, GJ/tonne CO2) towards regeneration energy (Qreg) was also examined. Results showed that the AMP-DA2MP blend possesses higher CO2 absorption efficiency (up to 36.17%), higher KGav(ave) (up to 65.85%), higher KLav (up to 28.29%) and lower Qreg (up to 32.54%) compared to the single solvent MEA. Also, MEA possessed higher initial amine solution utilized (28.86%) and lower initial amine solution cost (28.5%) compared to the AMP-DA2MP blend. This is an initial revelation that AMP-DA2MP can provide cost-effective CO2 capture from a lime kiln. |
راعي المشروع | ThispublicationwasmadepossiblebyNPRPgrant#7-1154-2-433fromtheQatarNationalResearchFund(amemberofQatarFoundation).Thestatementsmadehereinaresolelytheresponsibilityoftheauthors.TheauthorsgratefullythankCleanEnergyTechnologiesResearchInstitute(CETRi),FacultyofEngineeringandAppliedScience,UniversityofRegina,S4S0A2,Canada.WealsoacknowledgetheresearchequipmentsupporttotheCETRi,fromthefollowingsorganizations:NaturalSciencesandEngineeringResearchCouncilofCanada(NSERC),CanadaFoundationforInnovation(CFI),SaskatchewanMinistryofEnergy&Resources,WesternEconomicDiversification,SaskatchewanPowerCorporation,AlbertaEnergyResearchInstitute(AERI)andResearchInstituteofInnovativeandTechnologyfortheEarth(RITE).ThefirstauthorofthispaperalsoacknowledgesfinancialsupportfromtheSaskatchewanInnovationandOpportunityGraduateScholarship. |
اللغة | en |
الناشر | Elsevier Ltd |
الموضوع | CO2 capture Lime kiln AMP 1,5-Diamino-2-methylpentane CO2 absorption efficiency Regeneration energy |
النوع | Article |
الصفحات | 7102-7110 |
رقم العدد | 6 |
رقم المجلد | 6 |
تحقق من خيارات الوصول
الملفات في هذه التسجيلة
الملفات | الحجم | الصيغة | العرض |
---|---|---|---|
لا توجد ملفات لها صلة بهذه التسجيلة. |
هذه التسجيلة تظهر في المجموعات التالية
-
الأبحاث [494 items ]