عرض بسيط للتسجيلة

المؤلفJlassi K.
المؤلفMallick S.
المؤلفEribi A.
المؤلفChehimi M.M.
المؤلفAhmad Z.
المؤلفTouati, Farid
المؤلفKrupa I.
تاريخ الإتاحة2022-05-22T11:03:02Z
تاريخ النشر2021
اسم المنشورSensors and Actuators, B: Chemical
المصدرScopus
المعرّفhttp://dx.doi.org/10.1016/j.snb.2020.129058
معرّف المصادر الموحدhttp://hdl.handle.net/10576/31400
الملخصIn this work, graphene quantum dots (GQDs) were prepared from Graphitic waste. The resulting GQDs were evaluated for the potential application for resistive humidity sensors. The resistive humidity sensors were fabricated on the pre-patterned interdigital ITO electrodes using the three different concentrations (2.5, 5.0, and 10 mg) of GQDs in DMF. The GQDs films were deposited using the spin coating technique. The GQDs (10 mg/ml) based impedance sensors showed good sensitivity and lowered hysteresis as compared to the other ratios (2.5 and 5 mg) of the GQDs. The maximum calculated hysteresis of the GQDs (10 mg) based humidity sensor is around 2.2 % at 30%RH, and the minimum calculated hysteresis of the GQDs (10 mg/ml) based humidity sensor is approximately 0.79 % at 60 %RH. The response and recovery time found to be 15 s and 55 s, respectively. The interesting humidity-dependent resistive properties of these prepared GQDs make them promising for potential application in humidity sensing.
اللغةen
الناشرElsevier B.V.
الموضوعGraphene
Graphene quantum dots
Hysteresis
Nanocrystals
Semiconductor quantum dots
Facile preparation
Graphite waste
Humidity sensing
Impedance sensors
Interdigital
ITO electrodes
Resistive humidity sensor
Response and recovery time
Humidity sensors
العنوانFacile preparation of N-S co-doped graphene quantum dots (GQDs) from graphite waste for efficient humidity sensing
النوعArticle
رقم المجلد328
dc.accessType Open Access


الملفات في هذه التسجيلة

Thumbnail

هذه التسجيلة تظهر في المجموعات التالية

عرض بسيط للتسجيلة