عرض بسيط للتسجيلة

المؤلفAbdel-Khalik, Ayman S.
المؤلفDaoud, Mohamed I.
المؤلفAhmed, Shehab
المؤلفElserougi, Ahmed A.
المؤلفMassoud, Ahmed M.
تاريخ الإتاحة2016-05-01T13:32:02Z
تاريخ النشر2014-10
اسم المنشورIEEE Transactions on Industrial Electronics
المصدرScopus
الاقتباسA. S. Abdel-Khalik, M. I. Daoud, S. Ahmed, A. A. Elserougi and A. M. Massoud, "Parameter Identification of Five-Phase Induction Machines With Single Layer Windings," in IEEE Transactions on Industrial Electronics, vol. 61, no. 10, pp. 5139-5154, Oct. 2014.
الرقم المعياري الدولي للكتاب0278-0046
معرّف المصادر الموحدhttp://dx.doi.org/10.1109/TIE.2013.2297294
معرّف المصادر الموحدhttp://hdl.handle.net/10576/4472
الملخصDespite the increased interest in multiphase induction machines for safety-critical applications, machine parameter identification for the different sequence planes is still a challenging research point. In most available literature, the effect of nonfundamental sequence planes is overlooked due to the assumption of sinusoidal winding distribution and healthy operation. However, in a single layer or concentric winding layout with an odd number of phases, the effect of flux produced by nonfundamental sequence planes cannot be ignored for the open-phase case. This paper proposes a simple offline method to estimate the parameters of a five-phase induction machine corresponding to different sequence planes. The proposed technique can estimate the stator leakage inductance as well as the magnetizing inductance of both fundamental and third sequences by applying a quasi-square voltage to the stator winding while the machine is running at no-load. Consequently, the rotor circuit parameters of the fundamental sequence plane can be simply obtained by deducting the stator impedance from the blocked rotor machine impedance. For the third sequence plane, an approximate relation to estimate these parameters based on the measured fundamental sequence rotor parameters is also given. An experimental 1.5 Hp prototype machine is used to verify the proposed technique.
راعي المشروعThis work was supported by National Priorities Research Program (NPRP) Grant 09-1001-2-391 from the Qatar National Research Fund (a member of Qatar Foundation).
اللغةen
الناشرIEEE
الموضوعblocked rotor test
induction machine
Multiphase machine
no-load test
open phase
parameter identification
sequence planes
steady-state model
العنوانParameter identification of five-phase induction machines with single layer windings
النوعArticle
الصفحات5139-5154
رقم العدد10
رقم المجلد61


الملفات في هذه التسجيلة

الملفاتالحجمالصيغةالعرض

لا توجد ملفات لها صلة بهذه التسجيلة.

هذه التسجيلة تظهر في المجموعات التالية

عرض بسيط للتسجيلة