Search
Now showing items 11-16 of 16
Fault current contribution scenarios for grid-connected voltage source inverter-based distributed generation with an LCL filter
(
Elsevier
, 2013 , Article)
Inverter-based distributed generation (IBDG) is characterized by its negligible fault current contribution compared with synchronous generators due to its inherent non-overload capabilities. Thus, IBDG hardly affects the ...
High-performance adaptive Perturb and observe MPPT technique for photovoltaic-based microgrids
(
IEEE
, 2011 , Article)
Solar photovoltaic (PV) energy has witnessed double-digit growth in the past decade. The penetration of PV systems as distributed generators in low-voltage grids has also seen significant attention. In addition, the need ...
Capacitor voltage balancing using redundant states of space vector modulation for five-level diode clamped inverters
(
IEEE
, 2010 , Article)
A redundancy balancing technique for the five-level diode-clamped inverter is presented, which balances the four dc-link capacitor voltages at high modulation index and high power factor. The technique is based on dividing ...
Studying the effect of over-modulation on the output voltage of three-phase single-stage grid-connected boost inverter
(
Elsevier B.V.
, 2013 , Article)
Voltage boosting is very essential issue in renewable-energy fed applications. The classical two-stage power conversion process is typically used to interface the renewable energy sources to the grid. For better efficiency, ...
Switched mode power supplies for charge-up, discharge and balancing dc-link capacitors of diode-clamped five-level inverter
(
IET
, 2010 , Article)
Inductor switch mode power supplies (SMPS) operated in a discontinuous inductor current mode are used to balance the dc-link capacitor voltages of a diode-clamped five-level inverter. The SMPS concept is extended to charge ...
Non-linear backstepping control of five-phase IM drive at low speed conditions-experimental implementation
(
ISA - Instrumentation, Systems, and Automation Society
, 2016 , Article)
In this paper non-linear backstepping control (BSC) is employed for high performance five-phase induction motor drive for low speed operation. The traditional control approaches such as direct torque control and indirect ...