Search
Now showing items 11-20 of 30
The spectral and morphological studies of the conductive polyaniline thin film derivatives by the in situ copolymerization
(
Springer New York LLC
, 2017 , Article)
Thin film of copolymers of poly(aniline-co-2-iodoaniline) are obtained by in situ copolymerization of aniline and 2-iodoaniline as the startup monomers by chemical oxidation upon varying the molar feed to ratio of monomers ...
From Zirconium Nanograins to Zirconia Nanoneedles
(
Nature Publishing Group
, 2016 , Article)
Combinations of three simple techniques were utilized to gradually form zirconia nanoneedles from zirconium nanograins. First, a physical vapor deposition magnetron sputtering technique was used to deposit pure zirconium ...
An investigation into hybrid carbon/glass fiber reinforced epoxy composite automotive drive shaft
(
Elsevier
, 2011 , Article)
This paper examines the effect of fiber orientation angles and stacking sequence on the torsional stiffness, natural frequency, buckling strength, fatigue life and failure modes of composite tubes. Finite element analysis ...
Energy absorption capability of composite hexagonal ring systems
(
Elsevier, Ltd
, 2012 , Article)
An extensive experimental investigation of inplane crushing of composite hexagonal ring system between platens has been carried out. Woven roving glass/epoxy hexagonal ring system with different angles and arrangement were ...
An experimental investigation into mechanical behavior of hybrid and nonhybrid composite semi-elliptical springs
(
Elsevier, Ltd
, 2013 , Article)
This study introduces a new composite semi-elliptical suspension spring by utilizing fiber reinforced composite strength in principal direction instead of shear direction. Three types of composites were tested, namely, ...
Investigation of the effect of Al-8B master alloy and strain-induced melt activation process on dry sliding wear behavior of an Al–Zn–Mg–Cu alloy
(
Elsevier, Ltd
, 2014 , Article)
Abstract This study was undertaken to investigate the influence of Al–8B master alloy and modified strain-induced melt activation process on the structural characteristics and dry sliding wear behavior of Al–12Zn–3Mg–2.5Cu ...
Fracture Analysis of a Special Cracked Lap Shear (CLS) Specimen with Utilization of Virtual Crack Closure Technique (VCCT) by Finite Element Methods
(
Springer New York LLC
, 2017 , Article)
Some of the most important characteristics due to a fracture investigation of a special specimen are taken into account. Debonding considerations for a composite/steel cracked lap shear (CLS) specimen by utilization of ...
Severe plastic deformation of tubular AA 6061 via equal channel angular pressing
(
Elsevier, Ltd
, 2016 , Article)
Various severe plastic deformation (SPD) processes have been developed to produce metal tubes with ultrafine grain (UFG) structures. However, most techniques are complex and limited to working with components that are short ...
An optimization technique on ultrasonic and cutting parameters for drilling and deep drilling of nickel-based high-strength Inconel 738LC superalloy with deeper and higher hole quality
(
Springer-Verlag London Ltd
, 2016 , Article)
In this research work, an ultrasonic assisted drilling system is employed to apply both rotation and vibration to drill bits. The transducer horn transfers power very efficiently and changes tools effortlessly. The setup ...
A learning factory: Enhancing societal needs awareness and innovation through manufacturing class
(
Hamad bin Khalifa University Press (HBKU Press)
, 2015 , Article)
The manufacturing course is a common course in most Mechanical and Industrial Engineering programs around the world. In this course, various aspects of product design and manufacturing process selection are discussed. ...