Search
Now showing items 1-7 of 7
Investigation of inter-line dynamic voltage restorer with virtual impedance injection
(
IEEE
, 2010 , Conference Paper)
The Inter-Line Dynamic Voltage Restorer (IDVR) consists of several voltage source inverters connected to different independent distribution feeders with common dc bus. When one of the inverters compensates for voltage sag ...
Capacitor voltage balancing using redundant states of space vector modulation for five-level diode clamped inverters
(
IEEE
, 2010 , Article)
A redundancy balancing technique for the five-level diode-clamped inverter is presented, which balances the four dc-link capacitor voltages at high modulation index and high power factor. The technique is based on dividing ...
An active damping technique for a current source inverter employing a virtual negative inductance
(2010 , Conference Paper)
A grid connected CSI requires a CL filter stage. In this work, the isolation transformer leakage inductance constitutes this filter inductance. This CL filter is lightly damped for efficiency constraints. Hence, it is ...
Inverter-based versus synchronous-based distributed generation; Fault current limitation and protection issues
(
IEEE
, 2010 , Conference Paper)
The contribution of distributed generation (DG) to network fault levels depends heavily on the technology employed. In the case of directly connected rotating machines the fault behavior is well established; with synchronous ...
Investigation of inter feeder power flow regulator: Load sharing mode
(2010 , Article)
The Inter feeder Power Flow Regulator (IFPFR) proposed in this paper consists of several voltage source inverters with common dc bus; each inverter is connected in series with one of different independent distribution ...
New voltage regulation techniques for low voltage radial feed PWM inverter based distributed networks
(2010 , Conference Paper)
Grid voltage rise problems occur, especially at light loads, due to the proliferation of distributed generation. Two techniques are proposed for regulating the voltage in low voltage radial networks when inverter based ...
Switched mode power supplies for charge-up, discharge and balancing dc-link capacitors of diode-clamped five-level inverter
(
IET
, 2010 , Article)
Inductor switch mode power supplies (SMPS) operated in a discontinuous inductor current mode are used to balance the dc-link capacitor voltages of a diode-clamped five-level inverter. The SMPS concept is extended to charge ...