بحث بسيط
السجلات المعروضة 31 -- 40 من 50
Severe plastic deformation of tubular AA 6061 via equal channel angular pressing
(
Elsevier, Ltd
, 2016 , Article)
Various severe plastic deformation (SPD) processes have been developed to produce metal tubes with ultrafine grain (UFG) structures. However, most techniques are complex and limited to working with components that are short ...
Electrodeposition of Duplex Ni–B–Zn/Co Composite Coatings
(2020 , Article)
This research article focusses on the Ni–B–Zn/Co composite coatings synthesized via an electrodeposition process. Electrodeposited Ni–B composite coatings have several advantages, such as excellent corrosion as well as ...
Design development of aggregates cooling systems for hot weather concreting
(
Springer Netherlands
, 2015 , Article)
Using hot aggregates, in concrete production, results in a drop in compressive strength of the produced concrete. Various methods have been proposed for cooling concrete aggregates. This paper proposes new two designs for ...
Multivariate statistical process control charts based on the approximate sequential ?2 test
(
Taylor and Francis Ltd.
, 2014 , Article)
Similar to the univariate CUSUM chart, a multivariate CUSUM (MCUSUM) chart can be designed to detect a particular size of the mean shift optimally based on the scheme of a sequential likelihood ratio test for the noncentrality ...
Investigation of the effect of Al-8B master alloy and strain-induced melt activation process on dry sliding wear behavior of an Al–Zn–Mg–Cu alloy
(
Elsevier, Ltd
, 2014 , Article)
Abstract This study was undertaken to investigate the influence of Al–8B master alloy and modified strain-induced melt activation process on the structural characteristics and dry sliding wear behavior of Al–12Zn–3Mg–2.5Cu ...
Simulated annealing with auxiliary knowledge for process planning optimization in reconfigurable manufacturing
(
Elsevier
, 2012 , Article)
In this paper, three simulated annealing based algorithms that exploit auxiliary knowledge in different ways are devised and employed to handle a manufacturing process planning problem for reconfigurable manufacturing. ...
An investigation into hybrid carbon/glass fiber reinforced epoxy composite automotive drive shaft
(
Elsevier
, 2011 , Article)
This paper examines the effect of fiber orientation angles and stacking sequence on the torsional stiffness, natural frequency, buckling strength, fatigue life and failure modes of composite tubes. Finite element analysis ...
Porosity effects on post-buckling behavior of geometrically imperfect metal foam doubly-curved shells with stiffeners
(
Techno-Press
, 2020 , Article)
This papers studies nonlinear stability and post-buckling behaviors of geometrically imperfect metal foam doubly-curved shells with eccentrically stiffeners resting on elastic foundation. Metal foam is considered as porous ...
Analyzing exact nonlinear forced vibrations of two-phase magneto-electro-elastic nanobeams under an elliptic-type force
(
Techno-Press
, 2020 , Article)
The present paper deals with analyzing nonlinear forced vibrational behaviors of nonlocal multi-phase piezo-magnetic beam rested on elastic substrate and subjected to an excitation of elliptic type. The applied elliptic ...
Magneto-electric effects on nonlocal nonlinear dynamic characteristics of imperfect multi-phase magneto-electro-elastic beams
(
Elsevier
, 2020 , Article)
This paper studies nonlinear dynamic characteristics of a nonlocal two-phase piezo-magnetic beam including geometric imperfections by considering piezoelectric reinforcement scheme. The piezoelectric reinforcement can cause ...