Search
Now showing items 331-340 of 404
Novel Slippery Liquid-Infused Porous Surfaces (SLIPS) Based on Electrospun Polydimethylsiloxane/Polystyrene Fibrous Structures Infused with Natural Blackseed Oil
(
MDPI
, 2022 , Article)
Hydrophobic fibrous slippery liquid-infused porous surfaces (SLIPS) were fabricated by electrospinning polydimethylsiloxane (PDMS) and polystyrene (PS) as a carrier polymer on plasmatreated polyethylene (PE) and polyurethane ...
A Novel Design and Development of Multilevel Inverters for Parallel Operated PMSG-Based Standalone Wind Energy Conversion Systems
(
Institute for Ionics
, 2023 , Article)
The article presents the new power conversion for parallel-operated wind energy conversion systems. It has been formulated by new multilevel inverter (MLI) topologies with reduced switch counts, lowered conduction losses ...
Effect of carbon nanotubes on the bonding mechanism of non-corrosive reinforcements to concrete
(
Elsevier
, 2024 , Article)
This study aimed to assess the impact of waterborne pre-dispersed multiwall carbon nanotubes (MWCNTs) at a concentration of 0.2 wt % on the bond strength between concrete and non-corrosive reinforcements, including stainless ...
Purification of colloidal oil in water emulsions by cationic adsorbent prepared from recycled polyethylene waste
(
Elsevier
, 2024 , Article)
This study deals with removing crude oil droplets from colloidal oil in water emulsions. The target was the development of efficient adsorbents for the tertiary treatment of industrial-produced water (PW). The novel adsorbent ...
Photochemical grafting of polysulfobetaine onto polyethylene and polystyrene surfaces and investigation of long-term stability of the polysulfobetaine layer in seawater
(
John Wiley and Sons Ltd
, 2018 , Article)
Low-density polyethylene (LDPE) and polystyrene (PS) films with hydrophilic surface were prepared by photochemical grafting of sulfobetaine-based copolymer containing photolabile moiety, and long-term stability of the ...
Synthesis of Gemini cationic surfactants based on natural nicotinic acid and evaluation of their inhibition performance at C-steel/1 M HCl interface: Electrochemical and computational investigations
(
Elsevier
, 2023 , Article)
Herein, we prepare effective Gemini cationic surfactants (CSII, CSIV) and characterize them using FT-IR and 1HNMR spectroscopy. The adsorptive properties of CSII and CSIV at HCl/air and C-steel/HCl interfaces were examined ...
Correction: Pd/Ni-metal–organic framework-derived porous carbon nanosheets for efficient CO oxidation over a wide pH range
(
Royal Society of Chemistry
, 2022 , Article)
The authors regret that one of the funders of this work was omitted in the Acknowledgements section of the original publication. The correct acknowledgements are as follows: This work was supported by the Qatar University ...
Interfacial Engineering of Porous Pd/M (M = Au, Cu, Mn) Sponge-like Nanocrystals with a Clean Surface for Enhanced Alkaline Electrochemical Oxidation of Ethanol
(
American Chemical Society (ACS)
, 2023 , Article)
The interfacial engineering of Pd-based alloys (i.e., PdM with distinct morphologies, compositions, and strain defects) is an efficient way for enhanced catalytic activity; however, it remains a grand challenge to fabricate ...
Effect of bond enhancement using carbon nanotubes on flexural behavior of RC beams strengthened with externally bonded CFRP sheets
(
Springer Nature
, 2022 , Article)
This paper studied the effect of incorporation of carbon nanotubes (CNTs) in carbon fiber reinforced polymer (CFRP) on strengthening of reinforced concrete (RC) beams. The RC beams were prepared, strengthened in flexure ...
Influence of carbon nanotubes on phase composition, thermal and post-heating behavior of cementitious composites
(
Multidisciplinary Digital Publishing Institute (MDPI)
, 2021 , Article)
This paper experimentally investigates the influence of carbon nanotubes (CNTs) on phase composition, microstructure deterioration, thermal behavior, and residual mechanical strengths of cementitious composites exposed to ...