Search
Now showing items 31-40 of 55
Composite sandwich structures for crashworthiness applications
(2007 , Article)
Fibre-reinforced polymer sandwiches are promising materials for reducing vehicle mass, thereby improving the fuel economics. Nonetheless, to fully explore these materials as the primary structures and energy absorbers in ...
Influence of TiO2 nanoparticles incorporation to friction stir welded 5083 aluminum alloy on the microstructure, mechanical properties and wear resistance
(
Elsevier
, 2017 , Article)
The aim of the current study is to investigate the effect of addition of TiO2 nanoparticles and friction stir welding (FSW) parameter such as number of passes on microstructure, mechanical and tribological properties of ...
Severe plastic deformation of tubular AA 6061 via equal channel angular pressing
(
Elsevier, Ltd
, 2016 , Article)
Various severe plastic deformation (SPD) processes have been developed to produce metal tubes with ultrafine grain (UFG) structures. However, most techniques are complex and limited to working with components that are short ...
Electrodeposition of Duplex Ni–B–Zn/Co Composite Coatings
(2020 , Article)
This research article focusses on the Ni–B–Zn/Co composite coatings synthesized via an electrodeposition process. Electrodeposited Ni–B composite coatings have several advantages, such as excellent corrosion as well as ...
Design development of aggregates cooling systems for hot weather concreting
(
Springer Netherlands
, 2015 , Article)
Using hot aggregates, in concrete production, results in a drop in compressive strength of the produced concrete. Various methods have been proposed for cooling concrete aggregates. This paper proposes new two designs for ...
Multivariate statistical process control charts based on the approximate sequential ?2 test
(
Taylor and Francis Ltd.
, 2014 , Article)
Similar to the univariate CUSUM chart, a multivariate CUSUM (MCUSUM) chart can be designed to detect a particular size of the mean shift optimally based on the scheme of a sequential likelihood ratio test for the noncentrality ...
Investigation of the effect of Al-8B master alloy and strain-induced melt activation process on dry sliding wear behavior of an Al–Zn–Mg–Cu alloy
(
Elsevier, Ltd
, 2014 , Article)
Abstract This study was undertaken to investigate the influence of Al–8B master alloy and modified strain-induced melt activation process on the structural characteristics and dry sliding wear behavior of Al–12Zn–3Mg–2.5Cu ...
Investigating the corrosion under insulation (CUI) on steel pipe exposed to Arabian Gulf sea water drops
(
Trans Tech Publications Ltd
, 2016 , Conference Paper)
This paper is an endeavor to investigate an insulated mild steel pipe that exposed to three sea water drops rate (10, 30, and 50 drops/minute) at room temperature. Various experimental strategies were employed including ...
Simulated annealing with auxiliary knowledge for process planning optimization in reconfigurable manufacturing
(
Elsevier
, 2012 , Article)
In this paper, three simulated annealing based algorithms that exploit auxiliary knowledge in different ways are devised and employed to handle a manufacturing process planning problem for reconfigurable manufacturing. ...
An investigation into hybrid carbon/glass fiber reinforced epoxy composite automotive drive shaft
(
Elsevier
, 2011 , Article)
This paper examines the effect of fiber orientation angles and stacking sequence on the torsional stiffness, natural frequency, buckling strength, fatigue life and failure modes of composite tubes. Finite element analysis ...