بحث بسيط
السجلات المعروضة 231 -- 240 من 404
Engineering and understanding of synergistic effects in the interfaces of rGO-CNTs/PtPd nanocomposite revealed fast electro-oxidation of methanol
(
Elsevier
, 2018 , Article)
The developing human societies are being faced provoking energy crises due to higher demands of energy for increasing worldwide populations. The massive depletion of natural resources and global warming issues sound a laud ...
Enhancement of visible light-driven hydrogen production over zinc cadmium sulfide nanoparticles anchored on BiVO4 nanorods
(
Elsevier
, 2022 , Article)
Photocatalytic water splitting to produce H2 is a promising technology for clean energy generation. However, the use of expensive noble metals, toxicity, low charge separation efficiency and wide band gap of semiconductors ...
Lanthanum-zinc binary oxide nanocomposite with promising heterogeneous catalysis performance for the active conversion of 4-nitrophenol into 4-aminophenol
(
Multidisciplinary Digital Publishing Institute (MDPI)
, 2021 , Article)
This work intended to enhance the unique and outstanding properties of lanthanum by synthesizing its nanocomposite. A lanthanum-based nanocomposite was prepared by a simple and cost-effective “co-precipitation” method. ...
Highly conductive phase change composites based on paraffin-infiltrated graphite panels for photo/electrothermal conversion and storage
(
Elsevier
, 2023 , Article)
The extensive utilization of phase change materials (PCMs) for thermal energy harvesting, storage, and thermal management is often constrained by their inadequate thermal and electrical conductivity, form instability, and ...
Tailoring the deposition of MoSe2 on TiO2 nanorods arrays via radiofrequency magnetron sputtering for enhanced photoelectrochemical water splitting
(
Elsevier
, 2023 , Article)
MoSe2/1 D TiO2 nanorods (NRs) heterojunction assembly was systematically fabricated, and its photoelectrocatalytic properties were investigated. The fabrication process involves the growth of 1D TiO2 NRs arrays on FTO ...
Up-cycling plastic waste into swellable super-sorbents
(
Elsevier
, 2023 , Article)
Environmental pollution caused by plastic waste and oil spills has emerged as a major concern in recent years. Consequently, there has been a growing interest in exploring innovative solutions to address these challenges. ...
Understanding the mechanics of complex topology of the 3D printed Anthill architecture
(
Oxford University Press
, 2022 , Article)
The present work aimed to investigate the deformation behavior of complex ant mound architectures under compression. We have used the cement casting method to extract four different ant nest morphologies. These casted ...
Green energy powered - vapor, thermal and UV light assisted disinfection technology
(
Elsevier
, 2023 , Article)
Infectious diseases are responsible for an immense global burden of disease that impacts public health systems and economies worldwide. The rapid increase in the use of protective items has introduced an urge for their ...
Design and Development of Inexpensive Paper-Based Chemosensors for Detection of Divalent Copper
(
Springer Nature
, 2023 , Article)
Abstract: Simple, portable, and low-cost paper-based sensors are alternative devices that have the potential to replace high-cost sensing technologies. The compatibility of the paper base biosensors for both chemical and ...
An Improved Quality Inspection of Engine Bearings Using Machine Vision Systems
(
American Society for Testing and Materials
, 2022 , Article)
The growth of an industry is mostly based on the quality of the product. When there is a fault in the manufactured product in a batch, the entire batch is rejected because of a single faulty product. Quality has become one ...